Call (410) 465-4636

2010 Honda CR-V

//2010 Honda CR-V

2010 Honda CR-V

Honda CR-V

Mileage
120,842
Service Date
7/17/2019
Services Performed
  • Perform BG Intake System Cleaning. This service is designed to loosen and remove carbon build up on the air intake system of the vehicle. Decarbonizing Top Engine Service. Remove all necessary engine components to access intake system. Connect decarbonizing unit to vehicle air intake system. Start engine, perform decarbonizing service. This process uses strong detergents to loosen carbon deposits that have built up over years of engine operation. Once the carbon has been softened, the next process helps remove the carbon sludge from the intake system. The process also cleans the intake valves in the engine and loosens and removes carbon inside the engine. (The final step requires the vehicle to be driven and the fuel additive continues to remove carbon. We recommend using an entire tank of gas before re-filling the gas tank as not to reduce the dilution of the cleaner.) Remove cleaning equipment and re-assemble any necessary engine components. Road test vehicle for proper engine performance. Carbon build up in the engine robs power and performance. Carbon absorbs the fuel that is intended to burn and causes the engine to not perform properly. (Run too lean) Carbon build up deep inside the engine also causes the internal engine temperature to exceed normal levels and causes excessive air pollutants. Thus causing the vehicle to fail emissions.
  • Cabin Filter: This is an air filter for the inside of your vehicle. It filters out air born particulates from the outside air that comes from your heater and a/c unit. Remove lower dash panel, remove bracing rod as necessary to access the cabin filter. Remove and replace the filter unit. Re-assemble the interior components and test the blower function.
  • Trans Drain and Fill
  • Diff Fluid
  • Remove tires from vehicle. Set up on Computer Tire Balancer. Perform balance test. Remove all existing weights and re-test balance. Perform proper tire balance to true balance. Move tire position to cross tires going on front and move front tires straight back to rear. (Directional Tires cannot be cross rotated and must stay on the same side of the vehicle and can only be rotated front to rear.) Re-install tire on vehicle and road test for proper vehicle road handling. Note: If tires have not been rotated at proper intervals, the tires that were originally on the rear of the vehicle can have a chopped wear pattern on the tread and when re-positioned on the front of the vehicle may cause some vibration and noise. Balancing will not get rid of this noise. Some tires may quiet down after a few thousand miles. Others will continue to make noise until replaced. Note: Tires need to be related periodically to even out the wear to maximise the life of a tire. Front tires wear on the edges due to the steering. Rear tires wear more flat but will cup due to the light rear ends. Tire rotation is designed to keep the cupping and edge wear to a minimum. Wheel alignments should be performed every 15K miles.
  • SPARK PLUGS – Remove and Replace – All Applicable Models
 
Denis F. gave our service a 5 star review on 8/12/2019
2019-08-13T22:00:15+00:00